Back to Blog
Liquid rhythm in reason 9.57/5/2023 ![]() Here's a video I made about vocal processing in Reason.“Rhythm Doctor is intended to tell a full, overarching story of characters through the lens of a rhythm game, as well as provide players with the tools necessary to establish a community of user-generated content. As for reverb before or after other processing, I recommend experimenting and getting an idea of what works for your voice. Try dialing it back and see if that helps. The knob is located on the right side of the front panel of the reverb. If it sounds like your singing on Mars, you probably have the Dry-Wet knob on the RV7000 turned up too high, perhaps all the way. Especially with reverb though, be sure to not go overboard! ![]() in the headphones because it sounds more natural when recording. In fact, many vocalists (myself included) prefer to have some reverb, compression, EQ, etc. That doesn't mean, however, that you can't use inserts when recording. This will create a new output bus and route the selected tracks to it.Īs for processing, you do want to record your vocals dry. A shortcut to do this is to select each track you want sent to the bus and hit Ctrl/Cmd + G. You can do that by creating a new output bus and setting the audio output of each vocal track to the bus. One thing you could do in that scenario would be to bus all of your individual vocal tracks together, in order to process them as a group. This is a common technique, and I find it useful to double or triple the vocals in a chorus, for example. You could do what you describe to get a thicker, doubled vocal sound by recording another take and panning them hard left and right respectively. For overdubs/doubling, I'd create additional mono audio tracks as needed. If your track is stereo, I would recommend changing it to mono. ![]() If the width knob is missing on your mix channel (and the word "width" under where the knob would be is replaced by "mono"), your audio track is set up as mono - that knob only appears on stereo tracks.įor recording vocals, you usually want to record in mono (the voice is a mono source, and you're using 1 microphone), so you should be set up if your track is mono. I have tried a few but they make the vocals sound like I am singing on mars as it's very distant and odd sounding, and is it best to record the vocals dry and then add compression/ reverb etc afterwards? I will be recording myself so a bit tricky. ![]() Is each audio vocal track supposed to go on one channel and is this stereo? or do I duplicate each track and turn one pan to the left and one to the right to get a spread out thicker vocal? and where is the width supposed to be set at ?Īlso, I understand the RV700 effect is good for vocal but am unsure as to if to add this first after eq / compression etc. However, one of the audio channels on the mixing desk now has mono but the ' width' button is missing. ( Rode) I set up on Asio input 1&2 and in mono on the sequencer. I am using a Focusrite 214 audio card, and condenser mic. I've been recording instrumental stuff in Reason, but am about to attempt recording my vocals properly for the first time.Īny useful tips and advice would be much appreciated on the following.
0 Comments
Read More
Leave a Reply. |